How To Fill Fender Flare Holes. Ok so i removed my fender flares on my 2003 edge, it looks good, except for the holes. This is how i did it and what i used! What is the best way to fill fender flare holes w/o welding. The next step i took was to fill the slots with bondo. Here's the set of clips ready for bondo. Carefully drill through the holes on the flares into the wheel arches. Attach a 1⁄4 inch (0.64 cm) drill bit to your electric drill. You could use epoxy or some other plastic filler, but bondo is pretty easy to work with. I did a total overhaul of my land cruisers fender flares. I want to put bondo on em so i can. Drill holes in the fender flare that align with your vehicle's frame holes. What’s the best way to fill the holes from the former fender flares? Now, create 1⁄4 inch (0.64 cm) holes. I’m looking for ways to cover the holes in my fenders since removing the flares. I plan on covering the lower half or 1/3 with raptor liner when i.
from www.tacomaworld.com
I am probably going to bedliner over whatever i use to fill the holes. Attach a 1⁄4 inch (0.64 cm) drill bit to your electric drill. This is how i did it and what i used! Now, create 1⁄4 inch (0.64 cm) holes. Drill holes in the fender flare that align with your vehicle's frame holes. I’m looking for ways to cover the holes in my fenders since removing the flares. Here's the set of clips ready for bondo. You could use epoxy or some other plastic filler, but bondo is pretty easy to work with. I plan on covering the lower half or 1/3 with raptor liner when i. The next step i took was to fill the slots with bondo.
Filling the holes in the fenders after removing the flares Page 12
How To Fill Fender Flare Holes I’m not sure what i’m ultimately going to do so looking for a temporary solution to cover the holes. What is the best way to fill fender flare holes w/o welding. I am probably going to bedliner over whatever i use to fill the holes. Now, create 1⁄4 inch (0.64 cm) holes. Drill holes in the fender flare that align with your vehicle's frame holes. Carefully drill through the holes on the flares into the wheel arches. Attach a 1⁄4 inch (0.64 cm) drill bit to your electric drill. I did a total overhaul of my land cruisers fender flares. I plan on covering the lower half or 1/3 with raptor liner when i. You could use epoxy or some other plastic filler, but bondo is pretty easy to work with. I’m looking for ways to cover the holes in my fenders since removing the flares. Ok so i removed my fender flares on my 2003 edge, it looks good, except for the holes. What’s the best way to fill the holes from the former fender flares? Then, securely attach the flares to the wheel arches using the mounting. I want to put bondo on em so i can. The next step i took was to fill the slots with bondo.